Philips Vortex Flow Meter F-2200 Series Manual De Usuario

F-2200 Series Vortex Flow Meter Installation and Operation Guide • Revised 12/08

17 

 

 

ONICON F-2000 series vortex meters are supplied with an internal PT 1000 type RTD 

 

 

temperature sensor located within the shedder bar. This sensor provides an accurate 

 

 

temperature measurement at the point where the fl ow rate is being measured. Flow meters 

 

 

supplied with this option will display the medium temperature and deliver an output signal 

 

 

that is temperature compensated for mass and/or normalized fl ow. 

 

The standard F-2000 series vortex meter is a 2-wire loop powered device. Wiring  connections are shown 

 below.

! 

• 

Do not remove enclosure covers in any wet environment 

• 

Keep dirt and debris out of electronics enclosure 

• 

Keep threads lubricated (silicone based lubricant) 

• 

Do not over tighten covers. Use special tool for removal only.

4-20 mA

100 ohms 

minimum