Pfaff Water Heater 581 583 Manual De Usuario

Installation and commissioning

.05

Basic position of the machine drive unit

.05.01

On machines with PicoDrive and control unit P41 PD2

● Switch on the machine.

● Call up the parameter input by pressing the "scroll" key.

● To switch the function keys to input (LED in the TE key lights up), press the TE key.

● By pressing the corresponding +/- keys, select parameter "798" and service level C,

see Chapter Selecting the User Level in the separate Control Panel Instruction Manual.

● Select parameter "799" by pressing the corresponding +/- keys.

● Check whether the value is set at "2" and alter if necessary.

● Switch the machine off and then on again.

● Select parameter "800" by pressing the corresponding +/- keys.

● Check whether the value is set at "0" (balance wheel turns towards the operator) and alter

if necessary.

● Select parameter "802" by pressing the corresponding +/- keys.

● Check whether the value is set at "0" (= no reduction ratio) and alter if necessary.

● .By pressing the corresponding +/- key, select parameter "700"

● Sew a stitch by operating the pedal.

● Turn the balance wheel in the sewing direction until the descending needle is level with

the top edge of the needle plate.

● Conclude the adjustment of the sewing motor by pressing the "scroll" key

.05.02

With drive system MD-4-58-220-CE

● Press and hold button and switch on machine

● Parameter 176 is displayed.

● Call up parameter 181.

● Call up input level.

● Sew a stitch with the pedal function.

● Turn the handwheel in rotational direction until the needle point (approaching from above)

is on the upper edge of the needle plate.

● Confi rm entry.

● Call up parameter 192.

Call up input level.

Press button D+ to turn function "off".

Press button "S" to exit input.

A B