Teledyne Tablet Accessory T803 Manual De Usuario
Communications Setup and Operation
Teledyne API T803 CO2/O2 Analyzer Operation Manual
110
Table 6-3: LAN/Internet Configuration Properties
PROPERTY DEFAULT
STATE
DESCRIPTION
DHCP
ON
This displays whether the DHCP is turned ON or OFF.
Press EDIT and toggle ON for automatic configuration
after first consulting network administrator.
Press EDIT and toggle ON for automatic configuration
after first consulting network administrator.
INSTRUMENT
IP ADDRESS
This string of four packets of 1 to 3 numbers each (e.g.
192.168.76.55.) is the address of the analyzer itself.
192.168.76.55.) is the address of the analyzer itself.
GATEWAY IP
ADDRESS
0.0.0.0
Can only be edited when DHCP is set to OFF.
A string of numbers very similar to the Instrument IP
address (e.g. 192.168.76.1.) that is the address of the
computer used by your LAN to access the Internet.
A string of numbers very similar to the Instrument IP
address (e.g. 192.168.76.1.) that is the address of the
computer used by your LAN to access the Internet.
SUBNET MASK
0.0.0.0
Can only be edited when DHCP is set to OFF.
Also a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that identifies the LAN to which the device
is connected.
All addressable devices and computers on a LAN must
have the same subnet mask. Any transmissions sent to
devices with different subnets are assumed to be outside
of the LAN and are routed through the gateway computer
onto the Internet.
Also a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that identifies the LAN to which the device
is connected.
All addressable devices and computers on a LAN must
have the same subnet mask. Any transmissions sent to
devices with different subnets are assumed to be outside
of the LAN and are routed through the gateway computer
onto the Internet.
TCP PORT
1
3000
This number defines the terminal control port by which the
instrument is addressed by terminal emulation software,
such as Internet or Teledyne API’s APICOM.
instrument is addressed by terminal emulation software,
such as Internet or Teledyne API’s APICOM.
HOST NAME
T803
The name by which your analyzer will appear when
addressed from other computers on the LAN or via the
Internet. To change, see Section 6.3.3.
addressed from other computers on the LAN or via the
Internet. To change, see Section 6.3.3.
1
Do not change the setting for this property unless instructed to by Teledyne API’s Technical Support
personnel.
Note
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g.
“0.0.0.0”), the DCHP was not successful in which case you may have to
configure the analyzer’s Ethernet properties manually. See your network
administrator.
“0.0.0.0”), the DCHP was not successful in which case you may have to
configure the analyzer’s Ethernet properties manually. See your network
administrator.
Note
Check the INET settings the first time you power up your analyzer after it has
been physically connected to the LAN/Internet, to make sure that the DHCP
has successfully downloaded the appropriate information from your network
server(s). The Ethernet configuration propertis (Table 6-3) are viewable via
the analyzer’s front panel display.
been physically connected to the LAN/Internet, to make sure that the DHCP
has successfully downloaded the appropriate information from your network
server(s). The Ethernet configuration propertis (Table 6-3) are viewable via
the analyzer’s front panel display.
07276B DCN6418