Teledyne Tablet Accessory T803 Manual De Usuario
Teledyne API T803 CO2/O2 Analyzer Operation Manual
Basic Operation
61
4.4. SETUP MODE
The SETUP mode is used to configure the analyzer’s hardware and software
features, perform diagnostic procedures, gather information on the instrument’s
performance and configure or access data from the internal data acquisition
system (DAS).
features, perform diagnostic procedures, gather information on the instrument’s
performance and configure or access data from the internal data acquisition
system (DAS).
Note
Any changes made to a variable during one of the SETUP procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will beep to notify the
user that the newly entered value has been lost.
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will beep to notify the
user that the newly entered value has been lost.
For a visual representation of the software menu trees, refer to Appendix A-1.
The areas accessible under the SETUP mode are shown below:
Table 6-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
MENU
ITEM
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration
CFG
Lists key hardware and software configuration information
Auto Cal Feature
ACAL
(Special configuration; consult factory).
Internal Data Acquisition
(DAS)
DAS
Used to set up the DAS system and view recorded data
Analog Output Reporting
Range Configuration
RNGE
Used to configure the output signals generated by the
instruments Analog outputs.
instruments Analog outputs.
Calibration Password
Security
PASS
Turns the calibration password feature ON/OFF
Internal Clock Configuration
CLK
Used to Set or adjust the instrument’s internal clock
Advanced SETUP features
MORE
This button accesses the instrument’s secondary setup
menu
menu
See
Table 6-5
07276B DCN6418