Overland Storage SAN S2000 Manual De Usuario

©2010 Overland Storage, Inc.

c. Release and slide the middle member back into 

the outer member.

3. Attach the right inner member (

a. Facing the chassis, position the rail against the 

right side of the appliance with the locking tabs 
going through the holes on the rail.

b. Slide the rail toward the front to lock it.

This may require some force as it is a tight fit.

c. Secure the rail with its Phillips screw.

4. Repeat 

 to install the left inner member.

IMPORTANT:  Depending on your rack type, continue with 
either the 

1. Attach the left outer rail to the rack (

a. Position the rail against the inside of the rack front 

rail with the hooks in line with the holes.

b. Insert the bracket front into the rack rail and 

press down so that the hooks catch.
The spring-loaded tabs will extend into the hole to 
prevent the rail from unhooking.

c. Slide the rear segment of the bracket rearward 

until the hooks are in line with the correct holes.

d. Insert the bracket rear into the rack rail and press 

down so that the hooks catch and the tabs lock.

2. Repeat 

 for the right slide rail assembly.

3. Verify that the rails are level and straight.
Continue with 

Before installing the rails onto a unthreaded round-holed 
rack, the round-hole rail kit adaptors (

installed on the ends of the outer rails.

1. Attach the adaptors (

) to both ends of the 

rail:

a. Position the adaptor stamped “A” at the front of the 

left outer rail (end with the graphic label).

b. Press the adaptor onto the hooks and slide it 

upwards until it locks (clicks).

c. Repeat 

 for the left rear adaptor 

(stamped “B”).

2. Facing the rack, position the left rail in the rack, 

aligning the adaptor holes with the front left rack 
holes being used (

).

Middle Member Latch

Middle Member

Outer Member

Screw

Align Rear
Holes to Tabs

Hooks

Tab

A

B

(Front)

(Rear)

Adaptor

“A” Stamp