Overland Storage SAN S2000 Manual De Usuario

©2010 Overland Storage, Inc.

• Overland recommends grouping columns of drives of 

the same speed next to each other when possible.

Once the unit is in the rack, install the drives. Initially, 
the top row is empty and the other two rows are filled 
with drive blanks. Remove as many blanks as needed:
1. If a drive blank is in the slot where you are about to 

install a disk drive, remove the blank by pressing the 
lever release button and pulling it out.

2. Remove a drive assembly from the packaging.
3. Press the button to release the lever.
4. With the button on the right, position the drive 

assembly in front of the appropriate bay and slide it 
in (

) until resistance is felt.

5. Push the lever in to lock the assembly in the bay.
6. Repeat 

 for each remaining drive carriers.

IMPORTANT:  To maintain proper airflow and cooling, a 
drive assembly or a blank drive carrier must be installed 

in every slot. No empty slots are allowed.

Once in the rack, attach the front bezel (

):

1. Insert the bezel tabs into the flange holes.
2. Push the other side in until it latches (clicks).
3. If desired, lock the bezel.

All cabling and power connections are located on the rear 
panel of the SAN S2000 appliance (

). All unit 

cooling exhaust is handled through the rear panel.

1. Plug the network connection into Data Port 1.

Using a Category 5e (or better) cable, connect Data 
Port 1 on the appliance to a Gigabit Ethernet switch 
on the same LAN segment as the management 
system.

2. Attach the power cords to the AC Power sockets on 

back panel.

3. Plug the power cords into an UPS appliance or AC 

power source.

4. Make sure that a iSCSI Initiator and the .NET (dot 

NET) framework is installed on each Windows host 
before continuing.

5. Install the Windows SAN Manager Suite software 

from the supplied CD on a host computer attached to 
the same subnetwork.
• If Autorun is enabled, program launches an HTML 

contents page where you select the appropriate 
type of software to load (32-bit or 64-bit). 

• If you are using a Mozilla-based browser or 

Autorun is disabled, you need to use your file 
manager to browse the CD and launch start.html 
at the root level. 

6. Follow the on-screen instructions.

IMPORTANT:  Always turn on any EXP E2000 expansion 
units on before powering up your SAN S2000. This 

enables the head unit to discover the attached expansions.

1

2

1 - AC Power 

2 - Mouse Port

3 - Keyboard Port

4 - Dual USB Ports

5 - COM Port

6 - Video Port

7 - Data Port 1

8 - Data Port 2

9 - Active SAS Port