National Instruments Welding System 321645c-01 Manual De Usuario
Chapter 2
Function Reference — WFM_Group_Control
NI-DAQ FRM for PC Compatibles
2-422
©
National Instruments Corporation
generated after NI-DAQ executes RESUME. RESUME restarts waveform generation if
NI-DAQ has completed the number of iterations specified in
NI-DAQ has completed the number of iterations specified in
WFM_Load
.
operation = 5 (STEP): This operation initiates a waveform generation at the analog output
channels in the group when the trigger mode has been set up to STEPPED or BURST using
channels in the group when the trigger mode has been set up to STEPPED or BURST using
AO_Change_Parameter
call. To advance to the next stage defined in the sequence list, call
WFM_Group_Control
again with operation = STEP. In this way, you can step through all of
the stages defined in the sequence list.
Note
This value of operation = STEP is supported for the DAQArb 5411 devices only.