Jensen Tools MSR2007 Manual De Usuario
MSR2007
2
INSTALLATION
Before You Begin
Before you begin, always disconnect the battery negative terminal.
Important Notes
•
Before final installation, test the wiring connections to make sure the unit is connected
properly and the system works.
properly and the system works.
•
Use only the parts included with the unit to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
unauthorized parts can cause malfunctions.
•
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to your vessel.
modifications to your vessel.
•
Install the unit where it does not interfere with driving and cannot injure passengers if
there is a sudden or emergency stop.
there is a sudden or emergency stop.
•
Avoid installing the unit where it will be subject to high temperatures from direct sunlight,
hot air, or from a heater, or where it would be subject to excessive dust, dirt or vibration.
hot air, or from a heater, or where it would be subject to excessive dust, dirt or vibration.
Wired Commander Mounting
1.
Choose a mounting area for the wired commander that is clean and flat, allowing the rear
gasket to fully seal to the mounting surface.
gasket to fully seal to the mounting surface.
2.
Secure the wired commander using either of the recommended mounting methods
detailed in the diagrams below.
detailed in the diagrams below.
7/8” HOLE REQUIRED
FOR CABLE
FOR CABLE
M4 MOUNTING SCREWS (4-PCS)
MINIMUM SCREW LENGTH 1 1/2”
MINIMUM SCREW LENGTH 1 1/2”
7/8” HOLE REQUIRED FOR CABLE
M5X8 SCREWS REQUIRED FOR MOUNTING
MAXIMUM SCREW DEPTH IN COMMANDER 1/4”
MAXIMUM SCREW DEPTH IN COMMANDER 1/4”