Jensen Tools MSR2007 Manual De Usuario

MSR2007

3

1.

Choose a mounting area for the tuner/amp module that will provide plenty of ventilation to 
prevent the amplifier from overheating. The tuner/amp module can be mounted in the hor-
izontal or vertical position. Please note that when mounting in vertical position, do not 
mount with the harness exit points facing straight up, as water can collect around the 
chassis in these areas.

2.

Attach the 4 rubber mounting feet, provided, to the bottom of the tuner/amp metal plate. 
This will provide clearance from surface moisture and promote good ventilation for the 
heat sink.

3.

Using the shortest length of the recommended size screws possible, mount the tuner/ 
amplifier as detailed in the diagram on the right.

4.

Route the tuner/ amplifier harness and cable throughout the vessel as required. Keep 
some slack in the harness/ cables so it won't be too tight, as this can cause damage to the 
wires.

5.

Follow the wiring diagram carefully and make certain all connections are secure and 
insulated with crimp connectors or electrical tape to ensure proper operation.

6.

After completing the wiring connections, reconnect the negative terminal on the battery 
and turn the unit on to confirm operation (vessel accessory switch must be on). If the unit 
does not operate, disconnect battery, recheck all wiring and refer to the trouble-shooting 
guide located in the back of the manual.

When wiring is complete, reconnect the battery negative terminal.