Motion 42-02-S028 Manual De Usuario

4   Manual # 42-02-S028 A1

After connecting power, “INITIALIZING BOARD COMM” will appear on the USN-BASE 
assembly LCD display.

It is important that all communication wires are disconnected from the USN board before 
changing the device type.  Make sure all ethernet, CAN, and serial cables are disconnected. 

When making changes to settings:

• Press N to cycle through menu
• Press S to select
• Use S to move cursor
• Use +/- to change selection
• Press N to go to save menu
• Press S to save 

To begin configuration:

1. Set only the F7 switch UP.
2. Press N until Device Type is displayed.
3. Press S to select. Supported Device Types are:

• IMC  types: 

• Swing Panel Group
• Swing Panel Simplex

• PCA  types:

• PHC Simplex Standard
• PHC  Simplex  Ansi  2000
• PHC  Duplex  Standard
• PHC Duplex Ansi 2000
• PTC Simplex Standard
• PTC Simplex Ansi 2000
• PTC Duplex Standard
• PTC Duplex ASME 2000

• Motion 3000ES Escalator Controller

4. Select the Device Type.
5. Press N to go to save menu. Press S to save.

6. After the device type has changed, place the F7 switch down. 

7. Reset the USN board by pressing the RSTA button.

8. After the device reboots, confirm new device type is selected.