MegaTech Whirlwind 3000 Manual De Usuario
10
REPAIRINg YOUR WHIRLWIND 3000
• If the tail rotor disengages or breaks during flight gently pull off the damaged rotor.
Press on the new tail rotor included with your kit. Make sure the beveled side of
the rotor blades face toward the tail motor. Do not press the new tail rotor onto the
motor shaft too far or the motor will bind.
the rotor blades face toward the tail motor. Do not press the new tail rotor onto the
motor shaft too far or the motor will bind.
• Use Foam Safe glue to repair cracks or damage to the fuselage assembly.
• If any glued parts come loose, please use foam safe glue to reattach.
• If the stabilizer fly-bar breaks for any reason you can replace it. Start by removing the
• If any glued parts come loose, please use foam safe glue to reattach.
• If the stabilizer fly-bar breaks for any reason you can replace it. Start by removing the
stabilizer pushrods located on both sides of the fly-bar. Then remove the center steel
pin that holds the fly-bar to the main shaft. Install the new fly-bar onto the main
shaft. Reinsert the steel pin and make sure it locks into place. Then reattach the two
stabilizer pushrods.
pin that holds the fly-bar to the main shaft. Install the new fly-bar onto the main
shaft. Reinsert the steel pin and make sure it locks into place. Then reattach the two
stabilizer pushrods.
TIP: Always use extra care when handling parts on the Whirlwind 3000. Take your
time and be patient. Remember that it is important to use as little additional
material for repair as possible. The Whirlwind 3000 is lightweight and balanced.
Make sure to always balance your Whirlwind 3000 after a repair. An example would
be if you glue parts on the fuselage and the Whirlwind 3000 seems to lean or go to
one side in flight, you can add similar weight to the other side for balance.
time and be patient. Remember that it is important to use as little additional
material for repair as possible. The Whirlwind 3000 is lightweight and balanced.
Make sure to always balance your Whirlwind 3000 after a repair. An example would
be if you glue parts on the fuselage and the Whirlwind 3000 seems to lean or go to
one side in flight, you can add similar weight to the other side for balance.
SPARE PARTS LIST
Spare, repair and replacement parts are readily available for your Whirlwind 3000.
Should you need parts, visit your local hobby dealer first. If unavailable, you may order
directly from Megatech. Use this sheet as a guide
Should you need parts, visit your local hobby dealer first. If unavailable, you may order
directly from Megatech. Use this sheet as a guide
PART#
DESCRIPTION
MTC992002
REPAIR GLUE (½ OUNCE TUBE)
MTC951101
REPLACEMENT TRANSMITTER
MTC951102
TRANSMITTER BATTERY COVER
MTC951103
COMPLETE REPLACEMENT HELICOPTER - CH. A
MTC951104
COMPLETE REPLACEMENT HELICOPTER - CH. B
MTC960205
STABILIZER FLY-BAR WITH PUSHRODS
MTC960206
TAIL ROTOR BLADE
Telephone Orders: (201) 662-8500
Website: www.megatech.com
Fax Orders: (201) 662-1450
Email: sales@megatech.com