MegaTech Whirlwind 3000 Manual De Usuario

12

No green light on 
transmitter when charging 
or Whirlwind 3000 will not 
charge

Power switch on the Whirlwind 
3000 and/or the transmitter is 
not in the correct position for 
charging

Set the Transmitter power switch 
to “ON” and then make sure the 
Whirlwind 3000 power switch is 
set to “OFF”. Plug the charge cord 
into the Whirlwind 3000 and the 
green LED on the transmitter will 
come on.

Charger Cord is not properly 
plugged into the Whirlwind 3000 
charge port 

Check Charger Cord’s connection

Whirlwind 3000 is not flying 
high enough

You are not using good throttle 
control

Increase throttle speed to allow 
the Whirlwind 3000 to gain 
altitude or for the helicopter to 
fly at a desired altitude.

Whirlwind 3000 crashed into 
the ground while landing

You may have used to much tail 
rotor control stick input

Reduce the amount of tail rotor 
control stick input.  Only use very 
little input to keep the Whirlwind 
3000 level and stable when 
landing.

You may have reduced the 
throttle speed too quickly or too 
much 

Lower the throttle speed more 
gradually to allow the Whirlwind 
3000 to land softly.