Maxon Telecom WL7-VERS. C Manual De Usuario
PATENTS PENDING
33
11921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
NOTE: If there is a grounding
point on the frame, use it
to connect ground cable.
Skip step 8.
to connect ground cable.
Skip step 8.
8. Extend the ground cable to reach
vehicle frame (FIG. 33-2). Con-
nect to an existing grounding point
if available. If necessary, drill a
13/32” (0.406”) hole in vehicle
frame for bolting the ground cable
terminal lug (FIG. 33-2).
nect to an existing grounding point
if available. If necessary, drill a
13/32” (0.406”) hole in vehicle
frame for bolting the ground cable
terminal lug (FIG. 33-2).
VEHICLE
FRAME
3/8” LOCK
WASHER
GROUND
CABLE
3/8”-16 X 1” LG.
CAP SCREW
3/8”-16
HEX NUT
BOLTING GROUND CABLE
TO VEHICLE FRAME
FIG. 33-2
7. Uncoil the ground cable from the bottom of
the pump cover. Route the ground cable
on the Lift through grommet in vehicle fl oor
(FIG. 33-1A & 33-1B).
on the Lift through grommet in vehicle fl oor
(FIG. 33-1A & 33-1B).
GROUND CABLE ROUTED FROM LIFT
FIG. 33-1A
GROUND
CABLE
TERMINAL LUG
9. Bolt the ground cable terminal lug
to vehicle frame as shown in FIG.
33-2.
33-2.
GROMMET
NOTE: Clean the ground cable
connection point on the
frame down to bare metal.
frame down to bare metal.
NOTE: Apply dielectric grease to
all electrical connections.
BARE
METAL