Lexibook SM1760 Manual De Introducción

Automatic Learning Function

1. Learn function executes automatically and

runs for approximately 3 minutes when the

batteries are first installed in the receiver.

2. Within these 3 minutes, the receiver picks up

the temperature & humidity signals from the

remote sensor and displays the readings.

Manual-Learning (Searching for Remote Signals)

If a new remote sensor is added or if the signal is

lost (outdoor display blinking), the learning function must be executed again.

1. Press and hold CHN [4] for 3 seconds to start.

2. A beep sound indicates that the learning function has started.

3. The 'Channel' symbol will flash and unit will beep as each remote sensor

is detected.

4. Temperature & humidity readings of remote sensor are displayed on the receiver.

Note: Auto/Manual Learn will not operate while the radio controlled clock is receiving DCF77 or MSF

signals.

SM1760IM0036 GB5

English

GETTING STARTED

SETUP

SM1760IM0036 GB6

LOW BATTERY INDICATION: If the batteries of the remote sensor are low, the following indicator

will be displayed on the main unit. The indicator will also be displayed on the bottom left corner of the

remote sensorʼs screen. When the main unitʼs LCD display becomes dim, it indicates that the batteries

are low and need to be changed.

Note: if the sensor is exposed to very low temperatures for an extended period of time, the batteries

may lose power which may cause the transmission range to be limited. High temperatures also reduce

the battery performance.

Setting the remote sensor

Unscrew the battery cover and insert batteries to begin the settings.

The house code will flash for 8 seconds.

Select a house code (1-15) by pressing °C/°F [8] and then press

SET [7]. The house code is the frequency signal sent by the

remote sensor to the receiver. The remote sensors for each

receiver must be set to the same house code, and remember to

press SET.

The channel will flash for 8 seconds.

Select a channel (1-3) by pressing °C/°F [8] and then press SET [7]. The channel

function allows the receiver to identify each remote sensor. Each receiver can receive

up to 3 different remote channels. The preferred channel number (1, 2 or 3) for each individual

remote sensor can be assigned. However, channel 1 is used for collecting data from outdoor and

activating the weather forecast symbols. If you only have one remote sensor, please set it at

channel 1 and place it outdoors.
Humidity and temperature will be displayed.
Toggle between °C or °F temperature display by pressing °C/°F key [8].
Insert 3 x AA batteries at the back of the main unit.

Notes:

• The SM1760 comes with one receiver and one remote sensor. If you wish to buy additional sensors

please refer to the section ACCESSORIES at the end of this manual.

• Use a different house code if your weather station detects other signals from neighbouring sources.

Else, use default settings: house code = 01 and channel = 01