Honeywell Network Hardware NETAXS-123 Manual De Usuario
32
www.honeywell.com
Installing the NetAXS-123 Panels
Installation
Installation
lists the factory Add-On Board default settings for a door 3. These mappings should be used
for the readers, inputs, and outputs when either a 1- or 2-door Add-On Board is attached to the
board-to-board connector on the controller board.
board-to-board connector on the controller board.
Table 7: Factory Default Configuration Settings for Door 3
a
Readers A and B share the same connection.
Notes:
• Reader LEDs, while they are outputs, should never be used to control anything other than their
associated reader LEDs.
• Incorrect wiring of the reader to the panel can cause the panel to abnormally stop operating or
to operate erratically.
Type
Purpose
Web
Default
Name
Default
Name
Terminal
Block
Label
Block
Label
Reader A
Reader B
Other
Input
Egress/
Request to
Exit (REX)
Request to
Exit (REX)
Input 9:
Door 2
Egress
Door 2
Egress
IO-TB2
IN9 (REX)
IN9 (REX)
Input 9
a
Input 9
a
Door Status
Input 10:
Door 2
Status
Door 2
Status
IO-TB2
IN10 (STS)
IN10 (STS)
Input 10
a
Input 10
a
Reader
Tamper
Tamper
Input 11:
Door
TMPR-A
Door
TMPR-A
IO-TB3
TMPR A
TMPR A
Input 11
Reader
Tamper
Tamper
Input 12:
Door
TMPR-B
Door
TMPR-B
IO-TB4
TMPR B
TMPR B
Input 12
Output
Lock Relay
Output #11
IO-TB5
LOCK
LOCK
Output 11
a
Output 11
a
Reader LED
Output #12
IO-TB7
LED
LED
Output 12
a
Output 12
a
AUX Relay
Output #13
IO-TB5
AUX
AUX
Output 13
Reader
Buzzer
Buzzer
Future
Feature
Feature
IO-TB7
BZR
BZR
Output 14
a
Output 14
a