Harbor Freight Tools 2_1/2 gal. Wet/Dry Vacuum/Blower Manual Del Producto
Page 8
For technical questions, please call 1-800-444-3353.
Item 61162
SAFET
y
Op
ERA
TION
ERA
TION
M
AINTENAN
c
E
SETU
p
p
Blower Operation
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the Switch off and unplug the power cord from its electrical outlet before removing the power Head.
1. Pull out on the tabs on the sides of the
Power Head and pull up on it to remove it.
2. Clean the Tank out before using the appliance
as a Blower.
cAUTION! Any material left in
the Tank may be blown out, causing injury.
3. Reassemble the Power Head to the Tank,
making sure the tabs lock into place.
4. Remove the Hose from the Vacuum Port. Locate the
Blower Port opening at the rear of the Power Head.
Insert larger end of the Hose into the Blower Port.
Table B: REcOMMENDED MINIMUM WIRE GAUGE
FOR EXTENSION cORDS (120 VOLT)
NAMEpLATE
AMpERES
(at full load)
EXTENSION cORD
LENGTH
25′
50′ 100′ 150′
0 – 6
18
16
16
14
6.1 – 10
18
16
14
12
10.1 – 12
16
16
14
12
12.1 – 16
14
12
Do not use.
5. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to
use one heavy enough to carry the current
your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss
of power and overheating.
Table B shows
the correct size to use depending on cord
length and nameplate ampere rating.
If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
6.
cAUTION! Wear ANSI-approved
safety goggles before use.
7. Make sure that the Switch is in its off position.
Plug the Power Cord into the power outlet.
8. Hold the loose Hose end securely.
Turn the switch on to operate the Blower.
cAUTION! Do not point Hose toward
another person or animal.
9. To prevent accidents, turn off the appliance and
disconnect its power supply after use. Clean, then
store the appliance indoors out of children’s reach.