Ez Access Mobility Aid ez-access Manual De Usuario

- 14 - 

xiv) 

Attach support tube bracket to the center saddle bracket using ⅜” nylock 

nuts and ⅜” washers (FIG. 19). 

a. 

To ensure plumb support tubes, level the support tube brackets  

                (FIG. 20). 

b. 

Secure and tighten the ⅜” nylock nuts. 

c. 

Start two each ⅜” x ½” bolts without washers into the threaded 
holes on each support tube bracket. DO NOT TIGHTEN. 

 

- 19 - 

4) 

 

A) 

One pair of handrails is required for each ramp section. Handrails are 
interchangeable. 

B) 

When used in a multiple ramp run, joiner assemblies are used to connect 
handrails together. Refer to FIG. 24 for following steps: 

i) 

One end of the handrail tube is notched to accept the joiner assembly. 
Locate the notched end on each upper and lower handrail tube. 

ii) 

Slide joiner assembly into the notched end of handrail tube. Repeat 
process for both upper and lower handrail tube. 

iii) 

Slide the next handrail section over the joiner assembly. 

iv) 

Ensure that the tube ends are pushed firmly towards each other. 

v) 

Using the supplied 5/32” allen wrench, tighten setscrews in both joiner 
assemblies. 

vi) 

Join all handrails together in this manner.