Ez Access Mobility Aid ez-access Manual De Usuario

- 16 - 

e) 

If the ramp tread surface is over 36” in height, connect the brace    
assembly under the ramp as shown in FIG. 22. 

f) 

The brace assembly ends will need to be cut to desired length, and 

5/16” holes to attach the brace bands will need to be drilled at both 
cut ends. 

g) 

Ensure that all platform brace assemblies are secured before using  

platform. 

 

H) 

 

 i)        

Turn the ramp section upside down on a flat surface. Do this on cardboard 

or a lawn so that the ramp is not damaged (scratched or dented). 

ii) 

Install four ramp handrail end brackets (these will be used to attach handrails 
in a later step). 

a) 

For 4’, 6’, and 8’ ramps, use one at each outside corner of the ramp 
section using one 5/16” x 1½” bolt & washer into the threaded insert 
second from the end of the ramp (FIG. 15a). 

b) 

For 10' ramps, two additional ramp handrail end brackets are installed 
using one 5/16” x 1½” bolt and washer at the center of each ramp 
section (FIG. 15b).  
NOTE

: Ensure holes in ramp handrail end bracket align with threaded 

inserts in ramp. Install one fastener into either of the two inserts. 

 

 

 

 

- 17 - 

iii) 

Turn the ramp over to the upright position. 

a)        

Place the upper end of the ramp onto the supporting surface, i.e.,   

platform porch, etc. 

iv) 

Once the ramp is resting on the porch or platform, lift the upper end of the 
ramp and install the top transition plate into what will be the upper end of the 
ramp and the bottom transition plate into what will be the lower end of the 
ramp (FIG. 16).  

           NOTE: The bottom transition plate is the larger of the two. 
   

  

a)       

Maneuver the ramp to its desired position (FIG. 17).