GE Capital 24959 Manual De Usuario

10

Some combo (combination) devices (TV/DVR, TV/
DVD, DVD/DVR, etc.) require you to set up 2 dif-
ferent modes to control both parts of the combo. 
For example, if you have a TV/DVD combo, you 
might need to set up one code under the TV mode 
to control the TV and a separate code (under other 
modes) to control the DVD. 

This remote allows the 6 DVD/DVR transport 
buttons (i.e. PLAY, PAUSE, STOP, FF, REWIND, 
and REC) to operate the programmed TV, DVD, 
SAT, DVR, Cable device if the code has these 
button functions e.g. if you hvae programmed 
a SAT/DVR or Cable/DVR, etc. Otherwise the 
transport keys will punch-through to the last DVD 
or VCR programmed mode you used, i.e., the 
transport buttons control your DVD or VCR player 
even when you are in TV, SAT or Cable mode. If 
you want to enable this Punch-through feature to 
allow the transport keys to always control your last 
used DVD or VCR, please use the following steps: 

1.  Press and hold SETUP until the red indicator 

stays on, then release the SETUP button. 

2.  Press and hold PAUSE until the red indicator 

turns off, then release the PAUSE button. The 
PAUSE button needs to be held held for about 
3 seconds before the red indicator turns off. 

The punch-through feature can be disabled again 
by repeating the above steps.

Your remote allows you to select which device 
mode controls VOLUME and MUTE. This remote 
is initially set for all device modes to use their own 
Volume/Mute control if present. 

If the programmed code does not have Volume/
Mute operation, then VOLUME and MUTE will 
“punch-through” (hand-over) control to the TV-
mode device without you needing to change to TV 
mode. Note: Any mode chosen for Volume/Mute 
control must have its own Volume/Mute function or 
else VOLUME and MUTE will not function.