Garmin Edge 1000 Manual De Propietario

You can modify all of the settings you configured in the initial 

setup.

Select   > System > Device Reset > Initial Setup.

Follow the on-screen instructions.

Each time you turn on the device and acquire satellites, the 

device automatically detects your time zone and the current 

time of day.

Battery type

Rechargable, built-in lithium-ion battery

Battery life

15 hours, typical usage

Operating temperature range From -20º to 60ºC (from -4º to 140ºF)
Charging temperature range

From 0º to 40ºC (from 32º to 104ºF)

Water rating

IEC 60529 IPX7*

*The device withstands incidental exposure to water of up to 

1 meter for up to 30 minutes.

Battery type

User-replaceable CR2032, 3 volts

Battery life

Up to 4.5 years (1 hour per day)

Operating temperature 
range

From -5° to 50°C (from 23° to 122°F)

Radio frequency/
protocol

2.4 GHz ANT+ wireless communications 
protocol

Water rating

3 ATM*
NOTE: This product does not transmit heart 
rate data while swimming.

*The device withstands pressure equivalent to a depth of 

30 meters.

Battery type

User-replaceable CR2032, 3 volts

Battery life

Approximately 12 months (1 hour per day)

Operating temperature 
range

From -20º to 60ºC (from -4º to 140ºF)

Radio frequency/protocol

2.4 GHz ANT+ wireless communications 
protocol

Water rating

1 ATM*

*The device withstands pressure equivalent to a depth of 

10 meters.

Do not store the device where prolonged exposure to extreme 

temperatures can occur, because it can cause permanent 

damage.
Never use a hard or sharp object to operate the touch screen, 

or damage may result.
Avoid chemical cleaners and solvents that can damage plastic 

components.
Secure the weather cap tightly to prevent damage to the USB 

port.

Wipe the device using a cloth dampened with a mild 

detergent solution.

Wipe it dry.

You must unsnap and remove the module before cleaning the 

strap.
A build up of sweat and salt on the strap can decrease the 

ability of the heart rate monitor to report accurate data.

• Go to 

 for detailed washing 

instructions.

• Rinse the strap after every use.
• Machine wash the strap after every seven uses.
• Do not put the strap in a dryer.
• When drying the strap, hang it up or lay it flat.
• To prolong the life of your heart rate monitor, unsnap the 

module when not in use.

Do not use a sharp object to remove batteries.
Keep the battery away from children.
Never put batteries in mouth. If swallowed, contact your 

physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate 

material. Special handling may apply. See 

.

Contact your local waste disposal department to properly 

recycle the batteries.

Use a small Phillips screwdriver to remove the four screws 

on the back of the module.

Remove the cover and battery.

Wait 30 seconds.

Insert the new battery with the positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.

Replace the back cover and the four screws.
NOTE: Do not overtighten.

After you replace the heart rate monitor battery, you may need 

to pair it with the device again.

The LED flashes red to indicate a low battery level after two 

revolutions.

Locate the circular battery cover 

À

 on the back of the 

sensor.

14

Device Information