Garmin Edge 1000 Manual De Instrucciónes

À

Lap key. Select to mark a new lap.

Á

Action key. Select to start and stop the timer. Hold to turn on the 
backlight.
NOTE: This is the default functionality of the action key. The action 
key functions are programmable.

Â

Page key. Select to scroll forward through the data pages. Hold to 
scroll through the data pages in reverse.

Ã

Status LED.

Flashing green

Searching for a paired device.

Alternating red and green Attempting to pair with a new device.
12 rapid green flashes

Successfully paired with a device.

Four rapid green flashes

Successfully sent a command to a device.

Four rapid red flashes

Failed to send a command to a device.

The first time you connect the Edge remote to your Edge 

device, you must pair the remote with your device.

Bring the remote within 3 m (10 ft.) of the device.
NOTE: Stay 10 m (33 ft.) away from other ANT+™ sensors 

while pairing.

From the Edge home screen, select   > Sensors > Add 

Sensor > Edge Remote.

On the remote, hold two keys simultaneously until the status 

LED starts alternating green and red, and release the keys.
The remote searches for your device. When the remote pairs 

successfully, the status LED flashes green 12 times, and the 

remote name appears on the device.

Select the remote, and select Add.

After the remote is paired, it connects to your device whenever 

the device is in range and turned on.

From the Edge home screen, select   > Sensors > Edge 

Remote > Sensor Details.

Select Single Press or Press and Hold.

Select a function for the action key.
For example, you can set the action key to display the map 

or turn on the backlight.

Several mounts are available for your remote, either included 

with the product or as an optional accessory. The mounts allow 

you to attach the remote to your body, your bike, or other 

objects.

• Align two of the notches 

À

 with the sides of the mount, and 

press the remote into the mount until it clicks.

• Press gently on the release tab 

Á

, and lift the remote from 

the mount.

Do not use a sharp object to remove batteries.
Keep the battery away from children.
Never put batteries in mouth. If swallowed, contact your 

physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate 

material. Special handling may apply. See 

.

Contact your local waste disposal department to properly 

recycle the batteries.

Before you can replace the battery, you must have a small 

Phillips screwdriver, a small flat screwdriver, and a CR2032 

lithium coin-cell battery.

Using a Phillips screwdriver, remove the three screws from 

the back plate 

À

.

Remove the back plate from the remote.

Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and 

contacts from damage.

Carefully pry the battery from the back plate.

Install the new battery into the back plate with the positive 

side facing down.

2