GarrettCom - Garrett Communications Door 6K16 Manual De Usuario

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)

www GarrettCom com

* Note: The use of either multi-mode or single-mode fiber to operate at 100Mbps speed

over long distances (i.e., in excess of approx. 400 meters) can be achieved

only

if the following factors are both applied:

•

The 100Mb fiber segment must operate in full-duplex (FDX) mode, i.e. the
full-duplex (factory default) setting for 100Mbps fiber ports must be used,
and

•

The worst-case OPB of the fiber link must be greater than the fiber cable’s
passive Attenuation.

(Attenuation = Cable loss + LED aging loss + Insertion loss + safety factor)

5.0

Introduction - Magnum 6K16/6K16V Managed Fiber Switch Port

Modules

This chapter describes each Port Module (PM), including appearance,

functionality, and status displays.

5.1

Inspecting the Package and Product

This section applies only to PMs shipped as separate items, i.e., 6K16/6K16V

PMs not factory installed in a Magnum 6K16/6K16V PM slot.

Examine the shipping container for obvious damage prior to

installing a 6K16/6K16V PM; notify the carrier of any damage you believe

occurred during shipment or delivery. Inspect the contents of this package for

any signs of damage and ensure that the items listed below are included.

This package should contain:

1 or more 6K16-Series (6K16 or 6K16V) PMs

Installation instructions, with illustrations

Remove the 6K16-Series PM(s) from the shipping container. Be sure

to keep the shipping container should you need to ship any of the PMs

separately at a later date. In the event there are items missing or damaged,

contact your supplier. If you need to return the unit, use the original shipping

container if possible. Refer to Chapter 5 for specific return procedures.

5.2

6KPM Module Description

An important feature of the Magnum 6K16-Series is the use of Port Modules for flexible

mixed-media connectivity to RJ-45 and fiber media. Since the Magnum 6K16-

Series Switches have dual-speed capability for copper ports, the 2, 4, 6 or 8-port

interfaces are designed to support all standard Ethernet media types at 10 or 100

or 1000Mps speed. Each 6K16-Series PM provides a wide selection of

connecting Ethernet media segments with all similar or combo connector type.