Galaxy Metal Gear 65 Manual De Usuario

Galaxy 65 User Guide

182

You can blink the LED on a specific drive one of two ways:

• From the Drive Utilities Menu (only works for a single drive; see below)

• From the Display Drives list when you add a pool spare or display all drives (works for multiple 

drives). Select the drive and press B. Press B again to stop the blinking.

From the System Menu, select Utilities Menu and press Enter.
The Utilities Menu displays.

Select Drive Utilities Menu and press Enter.
The Drive Utilities Menu displays.

Select Blink Drive LED and press Enter 
The Select Drive screen displays.

Select the drive you want and press Enter.
The drive continues blinking its LED until you do one of the following:

• Press Esc before the Disk Array Administrator times out.

• Repeat the blink LED command, which toggles the blink LED command off.

Press Esc to stop blinking the LED.

The Down Drive function sets the status of a drive in a fault-tolerant array to down. This forces the Galaxy 
65 Subsystem to remove it from the array and marks the array as critical. At this point, you will be unable 
to take down any additional drives in the array.

If you have a properly sized dedicated or pool spare, this will cause a reconstruct on the affected array. 
For more information, see 

C.2.5, ”Reconstructing an Array”, on page 126

.

From the System Menu, select Utilities Menu and press Enter.
The Utilities Menu displays.

Select Drive Utilities Menu and press Enter.
The Drive Utilities Menu displays.

Select Down Drive and press Enter 
The Select Drive screen displays showing drives that are array members.