Elite ES700P Manual De Usuario

Introduction

The LS700P is a premium quality integrated powered subwoofer and amplifier. Created as an 

easy-to-setup addition to your PA, the LS700P will extend the bass of a typical sound system with a 

minimum of complication, and hence is intended primarily to operate with speaker level signals.

Configuration

The LS700P may be used in several different configurations, the minimum standard system is 

one LS700P used with a pair of full range speakers. The LS700P accepts the signal from sepa-

rate Left and Right sources simultaneously. It then combines them into one signal (to drive the 

internal speakers). When used in a setup where only one signal is provided to a speaker, such 

as a mono system or stereo with more than one LS700P, use either the Left or Right input.

This 

Subwoofer may be driven from Speaker Level 

or Line Level signals. If an 

élite processor is used, 

this Subwoofer should be plugged into the 

output of the processor. The 

Cutoff should be set to 150-Hz and the Input Level 

should be set to 

LINE. For 

Line Level operation a 

balanced (

Tip Ring Sleeve)  

cable should be used. If the 

system is being operated 

without a processor, this 

Subwoofer can be 

connected to the output of 

the power amplifier as shown 

in the diagrams and the 

Input Level should be set to 

SPEAKER. If none of the 

equipment has a 

U-ground, 

the 

INPUT GROUND should be set to 

GROUNDED. Otherwise the INPUT 

GROUND should be set to the 

position that best minimizes the hum.

For normal operation connect the 

 just like an ordinary speaker along with the full range speakers. The

"

INPUT LEVEL" switch should be set to "SPEAKER ." If the audio source does not have a "U" ground, eg. a ground pin on

the AC cord, the "

INPUT GROUND" switch must be set to "GROUNDED." The 

 may be wired before or after

the full range speakers. Use the left and right inputs when using a single 

 in a stereo system. Use either

the left or right inputs when using separate 

's for each side or when used in a mono system. The

 does not alter the signal to the full range speakers in any way. The 

 will not draw any

power from the amplifier driving the full range speakers. Please note that an external cross-over is not necessary.

1. Hi Frequency Cutoff Control

This control varies the frequency at which 

the LS700P rolls off the high frequencies. 

This provides part of a crossover function. 

This crossover function also combines with 

the natural low frequency roll off inherent 

of the full range cabinet (when the LS700P 

is not used with an élite processor). This 

control should be set to the closest possible 

frequency to 20 Hz below the crossover 

point that the full range speakers processor 

uses as it's crossover point.

If an élite processor is used, set the high 

frequency cutoff to maximum (160 Hz)  

2. Subwoofer Level Control

The subwoofer level control adjusts the 

amount of bass added to the sound 

system by the LS700P. This adjusts for the 

relative sensitivity of the companion full 

range speakers and the desired system 

frequency response. This control should 

be set by listening while operating at a 

medium level and then not changed. It is 

not possible to set this control properly at 

high levels since the limiter is determining 

the output level. Setting the level too high 

will over load the circuitry causing a loss 

of bass dynamics. The level control should 

not be set above the 9 o’clock position