Elite ES700P Manual De Usuario
6. Protection
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry does not
alter the frequency response as the level changes. At high levels the limiter will limit the gain of
the LS700P and hence if the user attempts to set the subwoofer level control at high levels the re-
sulting setting will be incorrect. The level control should be set while operating at low levels (under
10 watts). If the level control is set to high due to setting it at high operating levels the input circuit
will clip and the dynamics of the bass will be lost. This can happen without audible distortion since
the filters will filter out the distortion.
LS700P Configuration Examples
TWO SUBWOOFERS PER SYSTEM
LS700P
SUBWOOFER
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER
FULL–RANGE
SPEAKER
Right
Left
config02e-ls700p.eps
ONE SUBWOOFER, WITH MONO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER/s
Output
config01e-ls700p.eps
ONE SUBWOOFER, WITH STEREO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKERS
Left
Right
Left
Right
config03e-ls700p.eps
ONE SUBWOOFER USING ÉLITE PROCESSOR
LS700P
SUBWOOFER
POWER
AMPLIFIER
élite
PROCESSOR
FULL–RANGE
SPEAKERS
Left
Right
R
L
INPUT
INPUT
AMP OUT
AMP IN
MID/
HI
SUB
OUT
SUB
OUT
MID/
HI
L
R
config04e-ls700p.eps
Note: The LS700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our
E160 cabinets. The support tube can be adjusted up to it’s full 5-foot 4-inch extension safely as long as the LS700P
is
not inclined mor than 10° (10-degrees).
WARNING: Larger or heavier cabinets shound not be used!