Futaba 10CAG Manual De Instrucciónes

66

Throttle delay function THR-DELAY (ACRO):

The  THR-DELAY function is used to slow the response of the throttle servo to 
simulate the slow response of a turbine engine. A 40% delay setting corresponds 
to about a one-second delay, while a 100% delay takes about eight seconds to 
respond. For helicopters, see DELAYS, p. 103. 

This function may also be used to create a “slowed servo” on a channel other than throttle. This is accomplished by 
plugging the desired servo (Ex: gear doors) into CH3 (THR), throttle into an auxiliary channel such as 8, and then using 
VRPHFUHDWLYHPL[HV3OHDVHVHHRXU)UHTXHQWO\$VNHG4XHVWLRQVDUHDDWZZZIXWDEDUFFRP?IDT?IRUWKLVVSHFL¿FH[DPSOH

Activate  THR-DELAY for a ducted-fan 
replica of a turbine-powered aircraft. 
Slow the servo response byone second.

Open the THR-DELAY function.

for 1 second.

 (If BASIC,

again.)

to page 2.

to THR-DELAY.

Activate the function.

to MIX.

to ACT.

Adjust the RATE to match the desired 
servo speed. (Ex: 40%.)

to RATE.

to 40%.

Close menu.

Set up THROTTLE-NEEDLE mixing: see p. 65.
Adjust throttle’s END POINT: see p. 39.
Adjust throttle exponential (D/R,EXP): see p. 42.
Set up AILEVATOR: see p. 57.
Set up programmable mixes, for example, RUDDER-AILERON: see p. 68.
View additional model setups on the internet: www.futaba-rc.com\faq\

ACRO 

w h e n  t h ro t t l e  i s  a p p l i e d  r a p i d l y -
ACCE

to ACCE.

THROTTLE STICK to idle.

THROTTLE STICK full open 

quickly.

as needed.

H E L I

  o n l y :  s e t  c u r v e s  f o r  o t h e r 

conditions.

to condition name.

to next condition to edit.

Repeat above steps as needed.

Close menu.