Cisco Systems 3.2 Manual De Usuario
3-11
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 3 Configuring Ports and Interfaces
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
AP-Manager Interface
•
VLAN identifier
Note
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
that only tagged VLANs be used on the controller.
•
Fixed IP address, IP netmask, and default gateway
Note
The AP-manager interface’s IP address must be different from the management interface’s
IP address but must be on the same subnet as the management interface.
IP address but must be on the same subnet as the management interface.
•
Physical port assignment
•
Primary and secondary DHCP servers
•
Access control list (ACL) name, if required
Note
.
Virtual Interface
•
Any fictitious, unassigned, and unused gateway IP address, such as 1.1.1.1
•
DNS gateway host name
Service-Port Interface
Note
The service-port interface uses the controller’s factory-set service-port MAC address.
•
DHCP protocol (enabled) or
•
DHCP protocol (disabled) and IP address and IP netmask
Step 4
Click Save Configuration to save your changes.
Step 5
If you made any changes to the virtual interface, reboot the controller so your changes take effect.