Carrier Access Network Device Axxius 800 Manual De Usuario

Axxius 800 - Release 2.2

5-113

CLI Commands

set

set (router) ntp poll

Use the set (router) ntp poll command to specify polling of the NTP server every defined
number of seconds. Note: not operational in this release.

Syntax:

set {rtr_card-addr} ntp poll {seconds}

Example:

set 1 ntp poll 120

The example will Poll the Network Time Protocol server every 2 minutes, for
the Router card in slot 1.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{seconds}

The number of seconds between polls. Seconds range is 16 to 1024. Default is 16.

set (router) ntp server

Use the set (router) ntp server command to specify the IP address of the NTP server.

Note: not operational in this release.

Syntax:

set {rtr_card-addr} ntp server {ip-addr}

Example:

set 1 ntp server 10.10.10.0

The example will set the address to be used to access the NTP server to
10.10.10.0, on the Router in slot 1.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

{ip-addr}

The IP address of the NTP server, in the form of xxx.xxx.xxx.xxx, where xxx is between
0-255.

Setting the NTP server value to 0.0.0.0 will cause the Router to listen to and

process NTP broadcasts.