Carrier Access Network Device Axxius 800 Manual De Usuario

5-150

Axxius 800 - Release 2.2

CLI Commands

set

set (router-trunk) encapsulation

Use the set (router-trunk) encapsulation command to specify the encapsulation to use on the
TSR interface.

Syntax:

set {rtr_trunk-addr} encapsulation {setting}

Example:

set 2:1:5 encapsulation pppofr

The example will configure encapsulation on the Router card in slot 2, port 1,
trunk 5 to PPP over.

{rtr-trunk-addr}

{setting}

set (router-trunk) multilink group

Use the set (router-trunk) multilink group command to specify a Router trunk to be part of a
multilink PPP group. Note: It is recommended, for performance, that all of the individual links
in the multilink group have approximately the same bandwidth.

Syntax:

set {rtr-trunk-addr} multilink group {number}

Example:

set 3:1:1-2 multilink group 1

The example will form a multilink PPP group that combines trunk 1 and 2.

set 3:1:3 multilink group

The example will add a third trunk to the multilink PPP group from above.

{rtr-trunk-addr}

{number}

The multilink group number.

Range is 1-24.

slot

Slot number (1-8) that contains the Router card

port

Port number of the Router

trunk

Trunk number for this port, 1-24

Frame Relay as per RFC 2427

ppp

Point-to-Point Protocol (PPP) as per RFC 1661 and 1662

pppofr

PPP over Frame Relay as per RFC 1973