Carrier Access Network Device Axxius 800 Manual De Usuario
Axxius 800 - Release 2.2
5-165
CLI Commands
set
set (router-wan) trunk
Use the set (router-wan) trunk command to configure the trunk port or multilink group for a
specified WAN interface. If the trunk encapsulation is subsequently changed, this trunk
assignment is reset to 0.
specified WAN interface. If the trunk encapsulation is subsequently changed, this trunk
assignment is reset to 0.
Syntax:
set {rtr_card-addr} {"wan-name"} trunk
[multilink-group] {number}
Example:
set 1 "LosAngeles" trunk 3
The example will set the WAN interface named "LosAngeles" on the Router
card in slot 1 to be mapped to trunk 3.
card in slot 1 to be mapped to trunk 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
[multilink-group]
This optional parameter, indicates that the number is the multilink group to use, else the
number is the trunk number to use.
number is the trunk number to use.
{number} -
Number of the trunk or multilink group to use, range is 1-24.
set (router-wan) up/down
Use the set (router-wan) up/down command to set the specified WAN interface up or down.
Syntax:
set {rtr_card-addr} {"wan-name"} {down|up}
Example:
set 1 "LosAngeles" up
The example will enable the WAN interface named "LosAngeles" on the Router
card in slot 1.
card in slot 1.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{down|up}
down
Set the Router WAN to disabled.
up
Set the Router WAN to enabled.