ALTINEX PE1005 Manual De Usuario
SPECIAL APPLICATION
400-0384-003
9
6.
Click on the “Search” button to check for
new devices on the LAN.
new devices on the LAN.
NOTE: If you want to assign the IP manually, click
“Assign IP”. This method will require the
hardware address on the device and the
assistance of your IT Administrator.
hardware address on the device and the
assistance of your IT Administrator.
THE IP ADDRESS
7.
Once the device is located, click on the
device in the installer window and make
note of the Internet address.
device in the installer window and make
note of the Internet address.
CONFIGURE THE DEVICE
8.
The device may be configured using a web
browser or using a Telnet session. This
procedure uses the Telnet option. Click the
“Telnet” button and do not change the
default port number of “9999”.
browser or using a Telnet session. This
procedure uses the Telnet option. Click the
“Telnet” button and do not change the
default port number of “9999”.
9.
When the command window appears, press
ENTER when prompted to enter Setup
Mode and then select the factory defaults.
ENTER when prompted to enter Setup
Mode and then select the factory defaults.
10.
Next, select “Channel 1 Configuration”.
11.
View each line item as it appears. Press
ENTER to leave the default value, or enter
the new value and press ENTER.
ENTER to leave the default value, or enter
the new value and press ENTER.
NOTE: The “Port No.” in the configuration
menu is the COM port for use with
RS-232 communication software.
RS-232 communication software.
11.
Select “Save and Exit” to keep changes and
exit setup mode.
exit setup mode.
12.
Close the DeviceInstaller, setup is
complete. Use the port number assigned
above to communicate with the PE-1005
over the LAN.
complete. Use the port number assigned
above to communicate with the PE-1005
over the LAN.