Baby Trend 2.1 Manual De Usuario

SAFETY

position that places the shoulder strap level

with, or below the top of the child’s shoulder

and feed the shoulder harness under the

correct loop. To adjust harness slot unhook

the shoulder strap from the crotch buckle.

(Fig. 17) Feed the shoulder strap through the

harness spread slots. You can access these

slots from the rear of the seat. Feed shoulder

strap through appropriate slot and reattach

shoulder strap to crotch buckle.

• Carefully place the child in the stroller seat

and bring the safety harness around the child’s

waist and over the shoulders. Place the crotch

strap and between the child’s legs. Insert the

male end of each shoulder / waist belt into

the buckle on the crotch strap. Tighten the

harness to be snug around the child’s waist

and over the child’s shoulders. (Fig.18)

• To release, apply pressure to both sides of

each male clip until the clip is released.

(Fig. 19) This process requires a moderate

amount of effort so as to prevent an accidental

release by your child.

NOTE: Buckles may be hard to release when

1st used.

TRAVEL SYSTEM - Safety Belt

• Strap the safety belt over the infant car seat

through the seat belt slots on the infant car

seat, connect the buckles together (Fig. 20).

The safety belts for the infant car seat is

located in small pockets on outer sides of seat

pads. Tighten the strap so the infant car seat

fits snug and can't move.

IT IS VERY IMPORTANT THAT THE

INFANT CAR SEAT STRAP IS ALWAYS

TIGHTLY FASTENED AROUND THE

INFANT CAR SEAT.

JUMP SEAT - 3-Point Harness

• Secure the child with the jump seat 3-point

harness (Fig. 21) when child is sitting on the

jump seat.

PLATFORM - Safety Belt

• Secure the stand feature safety belt behind

child and engate buckle (Fig. 22). This is the

same safety belt you use to secure the rear

infant car seat.

TO RECLINE SEAT

FRONT SEAT

The front seat has a two position recline. To

recline the seat, rotate the recline bar and press

backward on the seat back. (Fig. 23) To place the

seat in the upright position, press upward on the

seat back while rotating the recline bar.

WARNING:

The upright

position should be used only for a

child that is at least 6 months old.

TO ATTACH INFANT CAR SEAT

To attach Baby Trend infant car seats (Fig. 24),

rotate child trays to the vertical postion first. See

rotate child tray for more details.

WARNING:

Avoid serious

injury from falling, ALWAYS use

the safety belt to secure the infant

car seat.

Recline the front seat back. Postion the infant car

seat, facing toward the rear of the stroller, so the

seat shell goes into the front child tray and latches

into place. (Fig. 25)

Check that the infant car seat is firmly locked onto

the child tray and

STRAP THE SAFETY BELT

OVER THE CAR SEAT

through the seat belt

slots on the infant car seat, connect the buckles

together. (Fig. 26) Tighten the strap so the infant

Fig. 18

Shoulder Strap

Squeeze

Adjust for a snug fit

Crotch Strap

Waist Strap

Fig. 19

Fig. 20

Fig. 21

Fig. 24

Fig. 22

Fig. 23

Fig. 25