Baby Trend 2.1 Manual De Usuario

Descargar
Página de 6
 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
 Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
car seat fits snug and can't move.  
IT IS VERY IMPORTANT THAT THE INFANT 
CAR SEAT STRAP IS ALWAYS TIGHTLY 
FASTENED AROUND THE INFANT CAR 
SEAT. 
DO NOT USE INFANT CAR SEAT 
WITHOUT THE SAFETY BELT.
 
To remove infant car seat: 
Unfasten the safety belt and store in pocket 
located on each side of seat, then squeeze the 
release handle located at the foot-end of the infant 
car seat and carefully lift upward. (Fig. 27)
 
 
 
JUMP SEAT 
 
 
SIT ON JUMP SEAT 
Have the child sit on the jump seat facing 
backwards. Secure the child with the jump seat 
3-point harness. Part of the 3-point harness is 
stored in the pocket on the back of the front seat. 
Put the seat belt around the child's waist, and 
buckle to the crotch strap (Fig. 28). Adjust the seat 
belt to be snug around the child's waist. 
 
STAND ON THE PLATFORM
Position the child on the platform on the back 
of the stroller. Be sure child is standing facing 
foward and hands are holding frame. Secure the 
stand feature safety belt behind child and engate 
buckle (Fig. 29). Be sure that the child's feet are 
fully on the platform at all times.
SAFETY
9
10
CAUTION:
 Read the 
following section completely before 
folding your stroller!
WARNING:
  Care must be 
taken when folding and unfolding 
the stroller to prevent finger 
entrapment.
TO FOLD STROLLER
• Close the canopy as described in the canopy 
section. 
• Pull stroller backward several inches to 
rotate the front wheels to the front. (Fig. 30)
• The stroller is folded by simultaneously 
pulling each trigger fold.  (Fig. 31)  When 
the fold latches are released, the handle will 
begin to fall toward the floor.  Release the 
fold buttons and press downward on the 
stroller handle until the stroller is completely 
folded.  Secure the stroller in the folded 
position by hooking the fold latch, located 
on the right side of the stroller, over the rivet 
that protrudes from the frame. (Fig. 32)
SEAT PAD 
To clean the seat pad, use only mild household 
soap or detergent and warm water on a sponge or 
clean cloth.
OTHER 
Check your stroller for loose screws, worn parts, 
torn material or stitching on a regular basis.  
Replace or repair parts as needed. 
FOLD
Fig. 26
Fig. 27
Fig. 29
Fig. 28
Fig. 30
Fig. 31
Fig. 32