Beckett CG10 Manual De Usuario

Install the burner and all wiring in accordance with the 
National Electric Code ANSI/NFPA 70 (Canada CSA 
C22.1) and all applicable codes and requirements.  
Wire the burner in compliance with all instructions and 
diagrams provided by the appliance manufacturer.  
Verify operation of all controls in accordance with the 
appliance manufacturer’s guidelines.

See Figure 9 for a typical wiring 
diagram, with the RM7895A fl ame 

safeguard control, for reference purposes only.  Check 
the literature that was packaged with the burner for the 
primary control manufacturer’s instructions and the exact 
wiring diagram for your specifi c burner.  

Safety controls are designed and installed to provide 
protection.
Do NOT tamper with or bypass any safety control.
If a safety control is not functioning properly, shut 
off all main electrical power and gas supply to 
the burner and call a qualifi ed service agency 
immediately.

y

y
y

Disconnect electrical power before installing or 
servicing the burner.
Provide ground wiring to the burner, metal control 
enclosures and accessories. (This may also be 
required to aid proper control system operation.)
Perform all wiring in compliance with the National 
Electrical Code ANSI/NFPA 70 (Canada CSA C22.1)

y

y

y

All covers or service access plates must be in place 
at all times except during maintenance and service.
This applies to all controls, panels, enclosures, 
switches, and guards or any component with a cover 
as part of its design.

y

y