Brother LW6091001 Manual De Usuario

1

2

3

4

5

6

7

8

9

z

Error Messages

When an error message appears on the display, follow the directions provided below.

The installed batteries are getting weak.

The following are likely causes.
• The batteries are installed with the negative and positive 

ends the wrong way round.

• Other types of batteries are being used with alkaline 

batteries.

• Old and new batteries are being used together.
• The batteries are about to run out.
If the power does not turn off automatically, press any key to 
clear the error message before turning the unit off.
Check that the correct batteries are being used, and are 
installed the right way round.

An incompatible AC adapter is connected. After the power is 
turned off automatically, use the AC adapter designed 
exclusively for your P-touch.

The tape cutter is closed when you try to print or feed tape. 
Turn the P-touch off and then on again before continuing.
When tape is tangled in the cutter, remove the tape.

There is no text, symbols or bar code data entered when you 
try to print or preview a label. Enter data before continuing.

There is no tape cassette installed when you try to print or 
preview a label, or feed tape. Install a tape cassette before 
continuing.

The tape cassette was changed while printing, etc. Make 
sure the correct tape cassette is inserted before printing.

There are already seven lines of text when you press the 
Enter key. Limit the number of lines to seven.

There are more than five lines of text when you press the 
Print or Preview key while using 18mm tape. Limit the 
number of lines to five, or replace with a larger width tape 
cassette.

There are more than three lines of text when you press the 
Print or Preview key while using 12 mm tape. Limit the 
number of lines to three, or replace with a larger width tape 
cassette.

* Press any key to clear the error message.