Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

The show command lets you view parameter and statistical values.  You can view a single parameter, a 
group of parameters, or a table with parameters.  (A table consists of rows with similar parameters.) 

To see a definition and syntax example, enter only show.  To see a list of available parameters, enter a 
question mark after show (example show ?). 

To view the current values of all system parameters:  show system 

See “Show and Set Parameters” on page 88 for a list of parameters that can be used with the show 
command. 

The upload command is used to transfer files from the MP.11/a to the TFTP server. 

To upload a file from the MP.11/a to the TFTP server: 

upload <tftpserveraddress> <path and filename> <filetype> 

where <filetype> can be one of these four values: 

config - Configuration file, the current settings of the MP.11/a 
image - Image file, embedded software for the MP.11/a 
bootloader - Boot software 
license - License file 

To issue repeated operations, use the asterisk (*) character in place of the options: 

Previously used optional values for the upload command is stored in TFTP parameters that you can 
view and change.  See the TFTP parameter table for details.

There are a few basic configuration parameters that you may want to set up immediately when you 
receive the MP.11/a.  For example: 

▪ 

Set System Name, Location, and Contact information 

▪ 

Set IP address for the MP.11/a 

▪ 

Configure interfaces 

▪ 

Set WEP Encryption and passwords 

▪ 

Download an MP.11/a configuration file from your TFTP server 

▪ 

Backup your MP.11/a configuration file 

▪ 

Reboot 

▪ 

Reset to factory defaults