Proxim Tsunami MP.11 and MP.11a CPN 65755B Manual De Usuario

The quit, done, and exit commands are used to disconnect and close the current CLI session. 

Use the reboot command to signal the MP.11/a to reboot after a specified number of seconds. 

The <number of seconds> parameter must be positive.  Specify a value of 0 (zero) for an immediate 
reboot. 

Use the save command to save the current configuration of the MP.11/a to flash memory. 

Use the search command to list the parameters supported by the specified table.  This list corresponds 
to the table information displayed in the HTTP interface.   

See “Table Parameters” on page 97 for details. 

The set command lets you change parameter values.  You can set a single parameter value, or you 
can set a group of parameters or a table with parameters.  If a parameter requires more than one value, 
the values must be separated by spaces. 

For example, to set the MP.11/a IP address parameter: 

set ipaddrtype static 
set ipaddr 1 ipaddress 10.0.0.12 

Some parameter values change only when the MP.11/a is rebooted.  In these cases, the CLI warns you 
that a reboot is required for the change to take effect. 

See “Show and Set Parameters” on page 88 for a list of parameters that can be used with the set 
command.