Holman qt14 Manual De Usuario

 

IF FURTHER ASSISTANCE IS REQUIRED: 
CONTACT STAR/HOLMAN FACTORY SERVICE TEAM AT 1-800-807-9054 

 

1

 
Unpack unit and components from container. Remove all visible packing material, inspect 
unit for damage. If damage is discovered, file a claim immediately with the carrier that 
handled the shipment. 
 
The following should be included in the container: 
 

•  1ea. baking oven with heaters, and conveyor belt in place. 

(NOTE): Remove heating element-shipping supports. 

•  1ea. stainless steel unload tray, 1ea. stainless “Bake Aid” bracket 

1ea. “Bake Aid” magnet label, 2ea. crumb trays & 4ea. metal legs. 

 

 
1. 

Attach legs by screwing into weld nuts. 

 
 
 
 
 
 
 
 
 
 
 
 
2. 

Anti Skid pads are available at no charge and may be adhered to the foot section of 
each leg to prevent sliding. Call 1-800-807-9054 for details. 

CAUTION: The National Sanitation Foundation does not approve use of these pads. 

3. 

Install unit in its operating position. The load & unload ends must be at least 6" from 
any vertical combustible surfaces. Allow sufficient space for operating personnel.  
Have an electrician connect input power to the unit in accordance with local electrical 
codes. 

 
WARNING:  MAKE SURE ALL INPUT POWER IS OFF BEFORE 
INSTALLING/REMOVING ANY PARTS. 
WARNING:  BEFORE INSTALLING UNIT, HAVE YOUR ELECTRICIAN CHECK WITH 
LOCAL POWER COMPANY TO DETERMINE ACTUAL VOLTAGE AT JOB SITE.  
WARNING:  BE ABSOLUTELY SURE THE GROUND (EARTH) CONNECTION IS 
PROPERLY WIRED. NEVER CONNECT UNIT TO POWER WITHOUT PROPER 
GROUND CONNECTIONS. IMPROPER GROUND MAY RESULT IN SEVERE INJURY 
OR FATALITY. 
 
4.  Before applying input power to the unit check heating elements for breakage. Do not 

apply power to the unit if a broken tube is found. If no broken tubes are found apply 
input power by switching the master On/Off toggle to the ON position. Turn conveyor 
belt speed control to the maximum setting and check all heater tubes and conveyor for 
proper operation.