Extron electronic Multi-Graphic Processor MGP 464 Manual De Usuario
Operation, cont’d
MGP 464 • Operation
3-4
PRELIMINAR
Y
6 feet
(1.8 m)
Part #70-335-01
9DBF-2.5mm TRS cable_031504.eps
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D
Connection
TRS Plug
Pin 2
Computer's RX line
Tip
Pin 3
Computer's TX line
Ring
Pin 5
Computer's signal ground
Sleeve
2.5 mm connector cable for the configuration port (part #70-335-01)
See chapter 4, “Software Configuration and Control,” for details about using
the configuration software and the SIS commands to configure the MGP.
Power-up and Default Cycle
When you first plug the MGP 464 into a power source, the LCD screen displays a
series of initial messages, followed by the default cycle of screens. These messages
continue to cycle on the LCD screen when the menu system is not in use. The
following flow diagram shows the order in which these screens appear.
Default Cycle
Multi-Graphic
Processor
2 sec.
Window 1 DVI
000.0 kHz 000.0 Hz
Window 2 RGB
000.0 kHz 000.0 Hz
2 sec.
Output Rate
1280 x 1024 @ 60 Hz
2 sec.
Extron
MGP 464DI V1.00
Power
on
Extron
MGP 464 V1.00
2 sec.
Window 3 RGB
000.0 kHz 000.0 Hz
2 sec.
Window 4 RGB
Freeze Enabled
2 sec.
2 sec.
Default cycle
N
From any menu or submenu, the MGP 464 saves all adjustment settings and
times out to the default screens after 20 seconds of inactivity.