Breckwell P4000 Manual De Usuario

 
This stove is provided with a 6-foot grounded electrical 
cord extending from the rear of the stove. We 
recommend connecting to a good quality surge 
protector that is plugged into a standard three-prong, 
120V, 60hz electrical outlet. Voltage variations can lead 
to serious performance problems. The Breckwell 
electrical system is designed for 120V AC with no more 
than 5% variation. Breckwell cannot accept 
responsibility for poor performance or damage due to 
inadequate voltage. If connected to an older, two-prong 
outlet, a separate ground wire should be run to a proper 
ground (refer this to a qualified technician). Always 
route the electrical cord so that it will not come in 
contact with any hot part of the stove. 
 

 
WARNING: DO NOT INSTALL IN A SLEEPING 
ROOM. 

 

For installation in a mobile home, an outside source of 
combustion air must be used (see “COMBUSTION AIR 
SUPPLY”). 

 

The P4000 must be grounded to the steel chassis of 
the home with 8 Ga. copper wire using a serrated or 
star washer to penetrate paint or protective coating to 
ensure grounding. 

 

The P4000 must be securely fastened to the floor of the 
mobile home through the threaded holes in the bottom 
of the stoves rear legs using 2, ¼-20 lag bolts that are 
long enough to go through both a hearth pad, if used, 
and the floor of the home. (See figure 11) 

 

Refer to “VENTING” for proper exhaust configurations. 

 

 

 

 

 

 

BOLT HOLES