Britax Regent Manual De Usuario

NOTE:

If a positive click is not heard, but the

LATCH connectors are in an upright position, you

should not switch the LATCH connector. The strap

may be too tight or twisted, or there may be debris

in the LATCH connector.

Rotate the child seat into the forward-facing

position. Ensure the bottom of the child seat

shell is in full contact with the vehicle seat

and the recline bar is resting against the

vehicle seat back.

Verify that the LATCH strap is routed

under

the

child seat cover and is not twisted. Attach the

remaining LATCH connector to the adjacent

LATCH anchor. (Fig. E)

The LATCH strap must be routed on the

outside of

recline bar.

The LATCH connector MUST be in an upright position (Fig. F).

A positive click confirms attachment.

Alternately pull each LATCH strap loop while pushing the

child seat firmly into the vehicle seat to evenly tighten the

LATCH strap.

Attach the Versa-Tether

hook to the vehicle’s designated

tether anchor. Remove all slack from the tether to secure. See

pages 26 – 27.

Store the excess webbing in a LATCH storage pouch on the

back of the cover.

Verify that all connections are secure, the LATCH strap is tight

and the child seat is secure.

The child seat is secure when it cannot be moved more than 1 inch front-

to-back or side-to-side at the belt path. If the child seat is not secure,

repeat this procedure or use an alternate seating position.

Lap-Shoulder Belt – Long Route

Figure A illustrates a typical

Long Route lap-shoulder

belt installation.

IMPORTANT:

Britax recommends that the Versa-

Tether

be used at all times. Using the tether will

improve the stability of the child seat and reduce the

risk of injury. Check your vehicle owner’s manual for

approved tether locations.

The recline bar must be used at all times

with this child seat. Insert the recline bar into

the holes on the rear of the child seat. Use a

rubber mallet to tap the recline bar ends into

the holes. See page 28 for details.

If the vehicle is equipped with a designated

tether anchor for the chosen seating position, remove the

Versa-Tether

from the pouch, loosen and place it up and over

the child seat back.

Place the child seat in the forward-facing position on the vehicle

seat. Ensure the bottom of the child seat shell is in full contact

with the vehicle seat and the recline bar is resting against the

vehicle seat back.

Pull the vehicle belt out and route through the belt slot farthest from

the vehicle buckle from the front to the rear of the child seat.

The vehicle belt must route

over the child seat cover and outside of the

recline bar.

Route the vehicle belt across the back of the child seat continuing

through the belt slot closest to the vehicle buckle, to the front of

the child seat shell (Fig. B).

The vehicle belt must be routed

over the harness straps on the rear of the

child seat.

Installation for Children 22 – 40 lbs.

Release

Button

Top