BMW 2011 328i Sedan Manual De Propietario

108

You can operate the device while the ignition is 
switched on.

If the device fails to function even after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or hold down the programmed memory 
button

1 of the integrated universal remote 

control. If the LED

2 on the integrated universal 

remote control flashes rapidly and then remains 
lit for about two seconds, the original hand-held 
transmitter uses an alternating-code system. If 
it uses an alternating-code system, program 
the memory buttons

1 as described under 

Alternating-code hand-held transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the device to be set. You will find information 
there on the possibilities for synchronization.
When programming hand-held transmitters 
that employ an alternating code, please observe 
the following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the section 
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the 
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the 
device to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 of 

the integrated universal remote control 
three times.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have any questions, please contact 
your BMW center.

<

Press the left and right memory buttons

1 for 

approx. 20 seconds until the LED

2 flashes rap-

idly: all stored programs are deleted.

1.

Hold the original hand-held transmitter at a 
distance of approx. 4 to 12 in/10 to 30 cm 
from the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the system of the 

respective original hand-held transmitter 
used.

<

2.

Press the desired memory button

1 of the 

integrated universal remote control.

3.

If the LED

2 flashes slowly after approx. 

20 seconds, press the transmit key of the 
original hand-held transmitter. Release 
both buttons as soon as the LED

2 flashes 

rapidly. If the LED

2 does not flash rapidly 

after approx. 15 seconds, alter the distance 
and repeat this step.

Online Edition for Part no. 01 41 2 604 582 - © 02/10 BMW AG