Kobe CHX9130SQB1 Instruccion De Instalación

Wiring to Power Supply

CAUTION

: If moving the cooking range is

necessary to install the hood, turn off the power in
an electric range at the main electrical box.  SHUT
OFF  THE  GAS  BEFORE  MOVING  A  GAS  RANGE.
RISK OF ELECTRICAL SHOCK.

THIS RANGE HOOD MUST BE PROPERLY

GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH
ALL

APPLICABLE

NATIONAL

AND

LOCAL

ELECTRICAL  CODES.    BEFORE  CONNECTING
WIRES,  SWITCH  POWER  OFF  AT  SERVICE  PANEL
AND LOCK SERVICE PANEL TO PREVENT POWER
FROM BEING SWITCHED ON ACCIDENTALLY.

8.  If  hood  is  operating  normally,  connect  three  wires

(black, white and green) to house wires and cap
with wire connectors.

9. Store wires in the wiring box.

Ductwork Installation

10. Use steel pipe to connect the exhaust on the hood

to the ductwork. Use duct tape to make all joints
secure and air tight.

Duct Cover Installation

11. Mark the position of the Duct Cover-Mounting

Bracket  {L}.    Use  reference  E  from  Table  2  and
measurements  on  page 16-17.   Attach  and  secure
Duct  Cover-Mounting  Bracket  {L}  with  two  screws
(not  provided).    Refer  to  Figure  17.    NOTE:  Inner
duct  cover  will  cover  the  Duct  Cover-Mounting
Bracket.

12. Position the entire duct cover up onto the hood.
13. Secure the inner duct cover with two (3/16” x 3/8”)

screws {K} to the Duct Cover-Mounting Bracket {L}.
Shown in Figure 18.

14. Fasten outer duct cover to Duct Cover Support {M}

with four (4 x 6 mm) screws {K}.

Figure 17

Figure 18

Attach Together