Marvel M18AFWPL Hoja De Especificaciones

13

-Light power supplies mounted 

in power module

Light

harnesses

from 

cabinet-

Figure 16

Solenoid 

water valve

Hose 

Fitting

Gasket

Compression 

nut

Copper Tubing

(provided by 

customer) tubing 

to run in front of 

power module on 

top of cabinet

Tube clamp (2)

Fill hose to 

ice maker

Sleeve

Figure 17

The water valve and the water line fittings are packed 

inside the cabinet in a plastic bag. 

Remove the two screws from the bracket which is on the 

left side of the of the power module cover. Use these two 

screws to install the water valve on the bracket as shown in 

Figure 17.

Slip solenoid valve compression nut and compression 

sleeve on copper tubing as shown in diagram. Tighten nut 

onto water valve with adjustable wrench.

    

Remove the red plug from the end of the ice maker fill hose 

coming from the cabinet and clamp the hose onto the water 

solenoid valve as shown. Tighten clamp securely. Turn on 

the water supply and check all fittings for leaks.

This clamp for tube positioning only.  

Check to make sure tube is not col-

lapsed or restricted after connecting 

opposite end to valve.

Bracket on left side 

of module cover

An inline water filter can be used with this ice maker and is 

recommended. A shutoff valve should also be installed in 

the water line. Do not use a self-piercing type valve.