Marvel M18AFWPL Hoja De Especificaciones

12

Figure 14

Rear 

shoulder 

screw-

Front 

shoulder 

screw-

When installed the power module is not fas-

tened to the cabinet. It must be removed 

when the cabinet is tipped or transported.

Use two or more people to move product.

Failure to do so can result in back or other injury.

Do not operate the  freezer in the presence of 

explosive chemicals or fumes.

-Junction box

-Cabinet leads

-Power

cord

Power module on

top of cabinet-

Figure 15

Make electrical connections from the top of the lower 

cabinet to the junction box at left side of module. With ice 

maker, be sure to plug the ice maker line into the module, 

and the solenoid valve as well. See module diagram 

Figure 15.

Run the power cord in front of power module on top of cabi-

net around the right side of power module to the electrical 

outlet. See Figure 15.

On 18" wide freezer only (M18AF): Plug in the (5) electri-

cal connectors for the lights coming from the cabinet into 

the (2) power supplies which are attached to the power 

module, see Figure 16.

Ice

maker

leads-

Water

valve-

Place module on top of the cabinet with rear shoulder 

screws resting on the locator brackets behind the front 

slots. Slide module toward the rear of the cabinet until the 

rear shoulder screws engage the slots in the rear of the 

brackets. Rest the front shoulder screws into the front slots 

of the brackets.

Check to make sure wiring and ice maker tubing is clear 

and not interfering with module seal. Do NOT start product 

during construction, as dust can block module condenser 

coils. If dust accumulates on coils, vacuum immediately, 

using a soft brush attachment.