Marvel M18AFWPL Hoja De Especificaciones

20

It is possible that doors may become out of adjustment in 

shipment.

If product is installed slightly “out of level”, doors may not 

line up properly. Check this BEFORE adjusting hinges.

Door gaskets occasionally compress in shipment. If gasket 

does not seal all around, warm slightly with a hair dryer 

and pull outward softly until magnet in gasket seals against 

cabinet.

To expose concealed door hinge screws, remove plug but-

tons if present. All hinge sections attached to doors adjust 

left or right. Top and bottom cabinet hinges are also adjust-

able in and out. See Figure 29 (shown without cabinet trim).

Figure 29

Loosen door 

hinge screws to 

adjust door left 

and right.

Loosen hinge 

screws to adjust the 

door in and out-

1.  Remove the gasket from the door front. (See Figure 

28). Do this by pulling the gasket out of the chan-

nel that holds it to the door front. This will expose the 

clearance holes for mounting the custom overlay panel. 

(See Figure 28).

2.  Set the door on the overlay panel and align edges. 

(See Figure 28). Clamp panel in position and mark pilot 

hole locations. Pick the required pilot hole size from 

"Table E" below and drill the pilot holes ensuring not to 

drill all the way through the overlay panel.

 Table E: Pilot Hole Drill Sizes for Wood Screws

Hardwood

 

9

⁄

64

" (3.6mm) Diameter

Softwood

1

⁄

8

" (3.2mm) Diameter

3.  Insert wood screws through clearance holes and 

tighten to secure overlay panel.

4.  Reinstall gasket into channel. Make sure the corners 

are fully inserted.

5.  Install the door back on the cabinet by reversing the 

procedure in Step 1.