GE RAG61 Instruccion De Instalación

WALL CASE WITH RAD10 DRAIN KIT

EXTERNAL DRAIN

SEE PAGE 34 FOR INTERNAL DRAIN

SEE PAGE 34 NOTE #6

SQUARE DRAIN HOLES

1/2” O.D. 90° ELBOW DRAIN TUBE

NEOPRENE SPONGE GASKET

STEEL MOUNTING PLATE

Alternate

6” long, 1/2”

O.D. straight

copper tube.

NOTE

: SHADED PARTS AND

SCREWS ARE INCLUDED

WITH RAD10 DRAIN KIT.

USE EITHER THE 90°

ELBOW TUBE OR THE

STRAIGHT TUBE

DEPENDING UPON THE

REQUIREMENTS OF THE

PARTICULAR

INSTALLATION.

USE TYPE “A” SCREW FOR METAL CASE (RAB71)

AND TYPE “B” SCREW FOR MOLDED CASE (RAB77)

TYPICAL INSTALLATION

CASE ANGLES (FIELD SUPPLIED)

REAR

GRILLE

WALL CASE

ROOM

CABINET

90° ELBOW

DRAIN TUBE

PROJECTION

BEYOND WALL

CASE

MIN. 2 SUPPORTS

FIELD SUPPLIED

FLOOR

Caulk around

perimeter of

wall case all

four sides

where it joins

the building.

3”

“A”

“B”

METAL

PLASTIC

SCREWS

WATER DRAINAGE

- Precipitation entering the unit through the outdoor louver may not be removed entirely by the

condensate removal system. The base pan flange is designed to allow excess water, either condensate water or

precipitation, to flow into the wall case and drain through two drain holes in the rear of the wall case. If there is more

water in the wall case than can be drained through these holes it will drain through the three overflow drain holes.

These drain holes must not be blocked when mounting or caulking the wall case.

For those installations where water draining from the drain holes is objectionable or where positive drainage is

desired, the RAD10 drain kit is available with either a 90° elbow or a 6” straight tube to be used either to connect to a

field supplied drain line or to allow the water to drip free rather than drain down the surface of the building.

NOTE

: Drain kit using either the 90° elbow tube or the straight tube may be installed without modification when using

RAG60 exterior grille. Drain kit using the 90° elbow tube may be installed without modification when using RAG61

through RAG66 exterior grilles. Modification must be made to the RAG61 through RAG66 exterior grilles when using

the straight tube. Modification must be made to the RAG67 grille if using either the 90° elbow tube or the straight tube

(see installation instructions with the RAG67 grille).