Summit CP351WADA Manual De Propietario
4
Introduction
The CP351W is a unique two-door refrigerator with a zero degree freezer. The
fresh food section is automatically defrosted; the freezer is manually defrosted.
The refrigerator compartment stores fresh foods at temperatures of 34°F (1°C)
and higher while the freezer maintains a temperature of 0°F (-17°C).
This product is not designed to operate in enclosed spaces. When placing
your unit, make sure you allow at least 4” of clearance on all sides.
Installation
1. Remove the exterior and interior packing. To remove any remaining tape or
glue, rub the area briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
Before Using Your Appliance
Do not use sharp instruments, rubbing alcohol, flammable fluid or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your refrigerator.
cleaners to remove tape or glue. These products can damage the surface of
your refrigerator.
2. When moving the appliance, do not tilt it more than 45° from the upright
position.
3. Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
cooling system from handling during transportation.
4. Clean the interior surfaces with lukewarm water using a soft cloth.
WARNING: Keep flammable materials and vapors such as gasoline away from
the refrigerator.
Installing Your Appliance
•
Place your appliance on a floor that is strong enough to support it when fully
loaded. To level your appliance, adjust the leg at the front of the appliance.
loaded. To level your appliance, adjust the leg at the front of the appliance.
•
To ensure proper ventilation for your refrigerator-freezer, leave at least 4" of
space on each side, 4" at the back and 4" above the unit.
space on each side, 4" at the back and 4" above the unit.
•
If you are installing the appliance next to a fixed wall, leave sufficient space
on the hinge side to allow for the door to swing open.
on the hinge side to allow for the door to swing open.
•
Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight can affect the refrigerator's coating and
heat sources can increase electrical consumption. Extremely cold ambient
temperatures may also cause the appliance to perform improperly.
heater, radiator, etc.). Direct sunlight can affect the refrigerator's coating and
heat sources can increase electrical consumption. Extremely cold ambient
temperatures may also cause the appliance to perform improperly.