Linksys RE2000 Manual De Propietario

 

Linksys Wireless-N Range Extender

Use this method if your client device asks for the extender’s PIN. 

1.  On the client device, enter the PIN listed on the extender’s Wi-Fi Protected 

Setup screen. (It is also listed on the bottom of the extender.) When the 

connection is complete, the Wi-Fi Protected Setup light on the extender 

is continuously lit.

2.  Click  OK  on the extender’s Wi-Fi Protected Setup screen within two 

minutes.

If you have client devices that do not support Wi-Fi Protected 

Setup, note the wireless settings, and then manually configure 

those client devices. 

To open the Site Survey page:
1.  Log into the browser-based utility (see “How to access the browser-

2.  Click the Wireless tab, then click the Site Survey page.

Select—To connect to a wireless network, click the button next to the 

wireless network name (SSID) in the Select column, then click Connect

.

SSID—Displays the name of neighboring wireless networks.
GHz—Displays the radio band (in GHz) of the neighboring wireless 

networks. (This column is available only with the RE2000.)
Signal Strength—Displays the relative position of the neighboring 

APs by indicating the power of the wireless signal received: 1 bar= 20%, 

2 bars=40%, 3 bars=60%, 4 bars=80%, 5 bars=100%. If no bar is displayed, 

the extender is located too far away from the upstream AP. Try to keep 

the signal strength between 60% and 100% for optimum performance. 

A  careful site survey will help in keeping this value within acceptable 

range to benefit from optimum performance.
Security—Displays the mode of security in use by the neighboring APs. 

If a network supports Wi-Fi Protected Setup, the Wi-Fi Protected Setup 

icon is also displayed.