Yamaha RXA3040 Manual De Propietario
PREPARATIONS
➤ Optimizing the speaker settings automatically (YPAO)
En
50
Measuring at one listening position
(single measure)
(single measure)
When “Multi Position” is set to “No”, follow the procedure below for
measurement. It takes about 5 minutes to perform the
measurement.
measurement. It takes about 5 minutes to perform the
measurement.
• If any error message (such as E-1) or warning message (such as W-1) appears,
• (RX-A3040 only)
Do not use the microphone base until the corresponding message appear on the
TV.
TV.
1
To start the measurement, use the cursor keys to
select “Measure” and press ENTER.
select “Measure” and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
measurement finishes.
(RX-A2040)
(RX-A3040 [when angle/height measurement is disabled])
Proceed to Step 3.
(RX-A3040 [when angle/height measurement is enabled])
Proceed to Step 2.
2
Perform the angle/height measurement.
a Use the cursor keys to select “YES” and press ENTER.
Select “NO” to cancel the angle/height measurement.
b Attach the supplied pole to the center of the microphone base.
Microphone base
Pole
ENTER
RETURN
1 2 3 4 5 6 7 8 9 10
Cursor keys